Setting up a Brick Paver Walkway or Brick Block Concrete

The use of Bricks or Pavers to produce a walkway or outdoor patio matches a home in a method that is unrivaled. In addition, setting up a Brick or Paver pathway does not always need a pro.

The secret to setting up a Brick or Paver Walkway is to very first correctly prepare the location where the bricks/pavers are to be set up. In addition, string lines should be strung on each side of the sidewalk.
When the location has actually been dug down, 3/4" gravel stone must be laid in and tamped down securely. The height in between the tamped down sand and the stringline need to equate to the density of the brick or paver.

Now that you have a steady base, position a 1" pipeline or ledger board the length of the walkway on either side of the walkway. Using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will create a level area to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the ready location. These strips will act as your sidewalk border and help to keep the stability and shape of the pathway.

The key to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will once again assist maintain the stability of the pathway.

Inevitably bricks/pavers will require to be cut or split when constructing the sidewalk. Unless you wish to purchase or lease a costly wetsaw, I would suggest acquiring a basic brick/paver splitter. It clay bricks is generally more info a sculpt with a wide end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the area where you wish to break the brick. Then using a hammer strike the butt end of the sculpt securely. You might need to do this a number of times. You may also desire to turn the brick/paver over and strike the other side of the brick using the hammer and chisle. Within one or 2 strikes the brick/paver ought to break easily. If your pathway has curves you will require to buy/rent a wetsaw.

After setting up the bricks, build up the outside edges with additional sand, and after that shovel in the topsoil and load down firmly.
Finally, spread stone dust over the brand-new sidewalk and sweep into the fractures. Repeat this process a couple of times to guarantee the fractures are totally filled. This will complete the interlocking of the bricks and help to get rid of any weed growth. Just add turf seed to the outdoors edges click here and you should have a lovely entrance to your home within a number of weeks.


In addition, installing a Brick or Paver sidewalk does not always require a pro. The secret to setting up a Brick or Paver Walkway is to very first effectively prepare the location where the bricks/pavers are to be installed. Now that you have a steady base, put a 1" pipe or ledger board the length of the pathway on either side of the pathway. These strips will act as your walkway border and aid to preserve the integrity and shape of the sidewalk. Inevitably bricks/pavers will require to be cut or divided when building the sidewalk.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments on “Setting up a Brick Paver Walkway or Brick Block Concrete”

Leave a Reply

Gravatar